TOPIC:

I have two minidsps running two 3 way active speakers handling all the crossovers and I’m a little confused about fir filters.  
I have the crossovers setup already and was looking to flatten the phase response of each driver. 
can I measure the drivers close or do I have to measure in seating position? 
I usually do normal eq corrections at 3 meters. Then I let my audyssey software handle the room modes under 3-400hz. Then I’ll use a moving mic method around my seating position and adjust from there 

do fir filters get implemented before eq? Do I measure the drivers very close or in seating position and with or without normal active crossovers I have in place? 

I can’t seem to find any decent tutorials on YouTube using a minidsp for a walkthrough just a lot of talk about things that make things more confusing for me. I have the rephrase software and can take measurements just don’t know how to go about getting the right data to implement some fir into my system. 

also, can I use fir for the actual crossovers? So I just rub the drivers open and use fir somehow to do the crossover for each? 
also, my seating position is 10 feet away.
thanks for the help. 

Any help appreciated 

There's quite a few tutorials cover thing this step-by-step on the miniDSP website.