TOPIC:

Reading the SHD manual there is a decent detail on how to integrate a sub with the SHD and eventually run dirac.
My setup is slightly different than what starts on page 45 in that i have two subs and my speakers are active with a signal passthrough. Gotta figure out how to route with those new variables but not the reason for the post.
On page 46 it states i check the "link" button within the xover section to link r speaker with left speaker. When i go to the xover section there is no "link" button for me to check.
If i am only using one aes cable to send both l and r signal to the speaker (with passthrough), is this "link" still necessary?
I tried to use it without the link (since it was not available for me) but i can only get a signal out of one speaker when in dirac. 
Any thoughts or help here would be appreciated.
Need to rely on the forum experts and experienced users as the manual is very poor wrt to details
Thanks, in advance
 

The link option is just to save time rather than being necessary but I'm confused why you can't see it. Could you post a screenshot of what you see in a crossover tab, and for your wider question of your signal routing tab?

Sure, i will do this later today.
Thanks

If I recall correctly, the Link button/checkbox may not appear until you first select the output channel that you want to link with. The dropdown (upper left) doesn't default to any other outputs... so first choose the one you want to copy to and the link button should appear. 

yup you are correct, I just figured this out and got it to work
Thanks