Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Support
Community Forum
Community Support
PWR-ICE
PWR-ICE250 - BTL power spec

NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.
  • Page:
  • 1

TOPIC:

PWR-ICE250 - BTL power spec 9 years 3 months ago #12916

  • john.reekie
  • john.reekie's Avatar Topic Author
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 3778
  • Thank you received: 1593
I noticed that on the product page and in the datasheet the power in BTL mode is specified as max 630W into 4 ohms. However the ICEPower 250ASX2 datasheet gives this spec into 8 ohms (page 8). The minimum allowable load for the amp in BTL mode is 6 ohms (page 5).

Please Log in or Create an account to join the conversation.

PWR-ICE250 - BTL power spec 8 years 9 months ago #15337

  • hochopeper
  • hochopeper's Avatar
  • Offline
  • Senior Member
  • Senior Member
  • Posts: 41
  • Thank you received: 5

I noticed that on the product page and in the datasheet the power in BTL mode is specified as max 630W into 4 ohms. However the ICEPower 250ASX2 datasheet gives this spec into <strong>8</strong> ohms (page 8). The minimum allowable load for the amp in BTL mode is 6 ohms (page 5).


I noticed that too, does make these hard to use for normal 4 ohm subwoofer drivers. I suspect a similar mistake was made on the PWR-ICE125 specs. Would be good to have the website fixed up perhaps?

Chris

Please Log in or Create an account to join the conversation.

Last edit: by hochopeper.

PWR-ICE250 - BTL power spec 8 years 9 months ago #15352

  • john.reekie
  • john.reekie's Avatar Topic Author
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 3778
  • Thank you received: 1593

I suspect a similar mistake was made on the PWR-ICE125 specs.


Hi Chris, no I don't think so, I am referring ONLY to the 250 amp.

The 125 module IS rated for operation into a 4ohm load when bridged. Please refer to the B&O datasheet for the 125 amp: www.icepower.bang-olufsen.com/files/solu...lass_d_amplifier.pdf

Please Log in or Create an account to join the conversation.

PWR-ICE250 - BTL power spec 8 years 9 months ago #15365

  • devteam
  • devteam's Avatar
  • Away
  • Administrator
  • Administrator
  • Posts: 9162
  • Thank you received: 1461
Dear All,

Very good point raised here and we're already updating the info online. Thanks for the warning.
miniDSP, building a DSP community one board at a time.

For any official support, please contact our technical support team directly @ support.minidsp.com/support/home

Please Log in or Create an account to join the conversation.
  • Page:
  • 1
Moderators: devteam
Support
Community Forum
Community Support
PWR-ICE
PWR-ICE250 - BTL power spec