TOPIC:

Hello Evryone,

I juste receive my minidsp nanoAVR HDA. Hope it will do the work I presume it can do

Ok I'm reading the doc, Install the app and look at the back of the boxe ...
First question : How did I know wich channel go where
In the application : FL out, FR out, sub out, etc.. but at the back of the boxe, out 1, out 2, out 3, etc....

Thank you in advance

Hello,

In the output tabs, when I click Xover, the name is "out ch1" is cheked, so I will assume this is the mapping

Regards,

When you click on Outputs the labels are along the top (or at least, they used to be, don't have a computer with the software installed on it with me at the moment)

John is correct. Output label editing in done on the INPUT and OUTPUT tabs. it carries over to the matrix.

DevTeam

Hello,

Thank you to have take time to answer my question.
My question was more about output mapping between the software and the hardware, and I found this information in xover tab.
No probleme to rename in the software.

Regards,