TOPIC:

Hello team,
Is there a way to deactivate the IR sensor?
I use it in behind an SHD studio and of course the remote acts on both devices.
For now I used some tape over it and it works fine but it’s of course a bit ugly.
(just hiding/covering the entire unit is not an option as I want to keep the manual access and the screen visible)

When I had 3 SHD before I directly taped over the sensor itself on the LCD pcb.
But with this new unit I wondered if there’s a better option, before I open it, since everything is probably more cramped inside.

Thx!
David

Bumpity bump!
 

I don't think there is a software capability to disable the sensor if that's what you're asking? 

It's not that uncommon for people to end up with more than one miniDSP so it would be a good update if different selectable remote control channels became a feature. For now I think you've already got your best options in mind I'm afraid.

Thx Ultrasonic, 
Yes, either though software, or an easy hardware solution.
There’s not much room to cover the sensor inside, I’ll re-open it to check again.
It was ok in the SHD.