Welcome, Guest

NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.

Page:
1

TOPIC:

DDRC-22D buggy power-up behaviour 3 months 2 days ago #65903

reverb
Topic Author
Offline
New Member
Posts: 3
Thank you received: 0

Hello,

I have been a DDRC-22D user since 2019, and currently have two units which both exhibit the same behaviour.
On power-up, the unit sometimes ends up in a state where it incorrectly loads the first filter set, regardless of the one that was last loaded. When it boots up in this state, all LEDs showing the active digital source are off, and the Dirac Live led and the filter set led #1 are on.

Pressing Dirac Live toggle on the remote control twice will immediately restore the configuration that was used during the last session before power down.

This behaviour is not deterministic, and it occurs on approximately 1 in 10 power-ups.

Is there a possible solution to this problem?

The problem is observable on all firmware versions used to date, with the last one being Rev 1.13 / May 2022.

Please Log in or Create an account to join the conversation.

Last edit: by reverb.

Page:
1

Moderators: devteam

Support

Community Forum

Community Support

Dirac Series

DDRC-22D buggy power-up behaviour