TOPIC:

hello! I have a minidsp SHD and I wonder how i set dirac to only measure/adjust up till 500hz ?  Cant find any settings in dirac software but i guess im blind

Have a good day!
David 

You do it when you get to the filter part of the process. Just drag the curtain on the right to the left until it’s at the desired upper limit. 

Deleted duplicate post

Just to add, you can't change what is measured, just the frequency range over which adjustments are applied. This is why it's not a pre-measurement settling like you were presumably looking for, but rather the post-measurement setting that @asx77 correctly described.

The logic here is that you may as well do a single full-range measurement which then gives you full freedom to try processing over different frequency ranges.

thank you both ! Found that setting! So if I make a full measurement and then drag the curtain on the right to 500hz .. then dirac only apply target curve / processing up to 500hz ?

 

That is correct. There is a similar curtain at the left that defines the bottom of the frequency range that Dirac will be applied to.