TOPIC:

So I just upgraded Dirac live to version 3.3.3 on my Windows 10  laptop
and did a Calibration with my Minidsp 88a- BM  (umik-2)
Meassurment went fine, Exported it to Config 1 and Config 2
After that i connected to die MiniDSP 88  and  in the Dirac tab   there are no Gain or Delays set
"Dirac live" is shown as Activ

Anyone else experiencing this?
 

No one else? 
Just remeassuerd
exported filters
still no delay or Gain  adjustment in dirac tab

 

Just reloaded a saved project from Dirac 3.3.3 with only changes to saved version being Target Curve adjustments, and to my disappointment it is not showing delay or gain settings.
Tried disabling delay gain and then re enabling with no joy.
NOT GOOD
I guess this has to go to DEV Support 

thx for confirming, i also did try 3.3.0 didnt work either   1point measurment
i tried 3.2.3 (i think)  didnt show gain/delay either   1point measurment

did go back to 3.0.14 which i had installed before 
Which version are u using`?

Still have 3.3.3 on my primary WIN 10 box but the configs loaded into my 3 88BM’s were all made using 3.3.1. 

I also have a Dirac powered receiver from NAD and it’s Dirac Configs R also created using 3.3.1

if I get ambitious I may do a 3.3.3 run on the NAD to see it stores delay/gain settings. 
mic it does then it be a conflict with MiniDSP HARDWARE interfacing with
3.3.3

ihave U submitted an official support request?

it is best way to engage for help 

JFB