Welcome, Guest
Username: Password: Remember me

NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.
  • Page:
  • 1

TOPIC:

DDRC-24 sound output stop since last Firmware Update 1.17 4 months 3 hours ago #60934

  • nborj
  • nborj's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 3
  • Thank you received: 0
Hello everyone,
since last FW update My DDRC-24 often cuts out all audio output, USB device seems to be working fine but no movement on output signal (green to red bar meter) in DDRC software and no sound going to the amp, to any other sound card or USB-DAC, hdmi (display speaker) of the computer are not affected... I wonder if heat may be involved, but even s 'it's hot in my house, this problem started at the time of the update...
Also if I do a cold reboot (unplug/plug power) of my DDCR-24, the sound comes back for a while and cuts out again.
Did you experience the same kind of trouble or did you have an idea?

Cordially

Please Log in or Create an account to join the conversation.

DDRC-24 sound output stop since last Firmware Update 1.17 3 months 4 weeks ago #60975

  • davemackay
  • davemackay's Avatar
  • Offline
  • New Member
  • New Member
  • Posts: 6
  • Thank you received: 1
I'm having a similar issue with a new MiniDSP 2x4HD (plug-in version 1.21; firmware version 1.17). However, my MiniDSP 2x4HD (only a week old) has never passed the audio signal to my subwoofers whereas your unit had been working.

An audio signal is being sent to the miniDSP via analog (RCA), but it's not seeing it and nothing is being sent to my subwoofers. If I disconnect the MiniDSP and connect the subwoofers directly everything works fine.

I don't know if I've failed to configure the unit adequately, or if there is a problem with the unit. Any suggestions would be welcome.

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
Moderators: devteam