TOPIC:

I own two DDRC24s with DIRAC Live for each one. Can I use DIRAC 3 on each one to:

1. Correct two mains (L & R) ?
2. Correct three subwoofers (two front on one input to outputs 1 & 2 and one rear on the second input to output 3) ?

This a home theater system. What process (workaround) could I use to combine the two corrections (i.e. integrate the subwoofers after running corrections above? Would running audyssey mt32 (with the dirac corrections on) help integration of the two? Would there be an integration solution possible by using REW analysis?

Any other advise would be helpful. I really do not want to spend any more money on minidsp hardware.

Bump?

You have to Run Dirac 3 on unit 1 and let it load correction files to that unit ...then unplug USB into unit 2 and repeat process for whatever speakers that unit is controlling,,,,, or you can ditch those units and get a DDRC88BM and do it without the sideways engineering....

The second DDRC24 would be tied to three subwoofers. Two in the front of the room tied to input 1 and one in the back of the room tied to input 2. If I didn’t already own two DDRC24s, I probably would have done as you suggested and gone with the DDRC88A/BM.

I don't know if Dirac 2/3 works with subs alone, IIRC there were some reports that it needs full frequency range. But you can try it and see I guess. If not just use REW to eq the subs.

After you're done with the separate setup then just run REW through the AVR and you may need to adjust the crossover or delays in the AVR.