Welcome, Guest
Username: Password: Remember me

NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.
  • Page:
  • 1

TOPIC:

Help with Dirac DDRC88 and 3.0 DL 3 years 3 months ago #49454

  • rts100x5
  • rts100x5's Avatar Topic Author
  • Offline
  • Elite Member
  • Elite Member
  • Posts: 193
  • Thank you received: 38
Before the update I had zero issues taking measurements ....several hours into troubleshooting 3.0 DL and I still getting LOW SIGNAL to NOISE error /DISMISS ....
What I have checked
UMIK1 does have a calibration file and I have tried the 90 degree and the other
I am logged into Dirac Live 3
I am launching DL 3 from within DDRC88
Speakers are configured under DISPLAY CONFIGURATION to small speakers /BM and subwoofer where appropriate
Making CERTAIN DL3 has access to my UMIK1
Making certain that the UMIK1 is my default input for recording
I have downloaded that page VOLUME CALIBRATION from the manual to make sure Im following instructions to the letter

But when I get to take a measurement the DL3 ...even though I have increased Master Output during pink noise and MIC GAIN to sufficient levels to green ..when I run measurement test , the signal level measured is very low....

any suggestions ?

Please Log in or Create an account to join the conversation.

Help with Dirac DDRC88 and 3.0 DL 3 years 3 months ago #49455

  • rts100x5
  • rts100x5's Avatar Topic Author
  • Offline
  • Elite Member
  • Elite Member
  • Posts: 193
  • Thank you received: 38
Solved ---in DL3 the Input / list overlaps the web page to the far right / scroll over far right and a arrow /cursor appears allowing you to see additional recording devices ....Microphone / UMIK1 (instead of Windows Default /Microphone which I had chosen) ...was there and all measuring is not done without a hitch....

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
Moderators: devteam