TOPIC:

Hi all,

I continually get the “No devices found” on Dirac start-up after entering the IP of the Wi-DG, for Dirac to connect to over wi-fi.
(running Dirac 2.5.3 from the plug-in/app version 1.92d2)
Analysing the traffic on my network during an attempt, I can see a SSDP M-SEARCH request that fails with a message: “Destination unreachable (Port unreachable)”.

Any suggestions to get Dirac working?

(The minidsp plug-in works correctly over the same wi-fi setup)
(I can access the Wi-DG via a browser and the mobile app without any problems)
(The mike is connected as well)
(Dirac works fine over usb connections)

The source address is Dirac and the destination is the Wi-DG connected to the DDRC-24 for the below network data:

Internet Protocol Version 4, Src: 192.168.10.191, Dst: 192.168.10.122
0100 .... = Version: 4
.... 0101 = Header Length: 20 bytes (5)
Differentiated Services Field: 0x00 (DSCP: CS0, ECN: Not-ECT)
Total Length: 129
Identification: 0x0078 (120)
Flags: 0x0000
Fragment offset: 0
Time to live: 128
Protocol: UDP (17)
Header checksum: 0xa36a [validation disabled]
[Header checksum status: Unverified]
Source: 192.168.10.191
Destination: 192.168.10.122
User Datagram Protocol, Src Port: 57481, Dst Port: 1900
Simple Service Discovery Protocol
M-SEARCH * HTTP/1.1\r\n
HOST: 239.255.255.250:1900\r\n
MAN: "ssdp:discover"\r\n
MX: 4\r\n
ST: upnp:rootdevice\r\n
\r\n
[Full request URI: http://239.255.255.250:1900*]
[HTTP request 1/2]
[Next request in frame: 4]

on front page of widg product :
WARNING: The WIDG is only compatilbe with miniDSP plugins. Unfortunately it can't be used with Dirac Live software for control.

Thanks...don't think that was there when I bought it 3+ months ago