TOPIC:

Folks.
Have tried running DL2 on a win 10 laptop but DL2 fails to connect with the prompt: Cannot reach or connect to Dirac services with a suggestion that I check my firewall and network settings.
I have attempted following the tips and tricks post specifically regarding network firewal settings (see below) and with command prompts checked ports 8080 and 5000 (and all the others) and didn't get any outputs. Assume this means these ports are open and my problems lie elsewhere?
I have mcafee running
Has anyone encountered similar problems, that they have solved........?


Security/Firewall/Ports
- Dirac live uses port 11113, 11115 and 11117, 5000 and 8080. Make sure that your firewall isn't blocking these ports as Dirac bridging app need these two ports to talk between device and Dirac Live. Under Win10, you can check by opening command prompt and type:
netstat -ano | findstr 8080
and
netstat -ano | findstr 5000
If no output, it will be all good. Else, try to close the app which used those ports.

Which miniDSP are you using? Are you trying to launch Dirac Live via the appropriate plugin?

DDRC24, and yes using the correct plugin for it, and launching DL2 from within the plugin as advised.

Are you able to connect to the DDRC-24 OK using the plug-in?

Which version of Dirac Live are you using? Maybe try a different one?

live.dirac.com/all-released-versions/

Yes connecting to DL2 through the plug in. Have tried 2.2.3 of DL as well as the current version but same problem

Tagore wrote:

Yes connecting to DL2 through the plug in. Have tried 2.2.3 of DL as well as the current version but same problem

You misunderstood my first question there. I was asking if you could connect to the DDRC-24 using the plugin. As in using the Connect button at the top right rather than launching DL.

Ah. Understood. Yes can connect to the DDRC24 using the connect button in the plugin.