Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Support
Community Forum
Community Support
Dirac Series
Bootloader mode

NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.
  • Page:
  • 1

TOPIC:

Bootloader mode 4 years 5 months ago #39616

  • EdvardGreig
  • EdvardGreig's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 1
  • Thank you received: 0
Hi All

I was messing around in the DDRC-88-BM software and found a button labeled upgrade firmware in Restore menu, I clicked it and it brought me to a screen where it asked for a hex file. It connected to the unit and the lights on the front of the unit went to only 1 LED being lit instead of 2 like usual. I exited the firmware upgrade dialog box without doing anything. Now I cannot get the unit to output any signal and the remote control doesnt work. I cannot use the DDRC-88BM software to connect to the unit to control it either. I havent taken out any USB cables or turned the unit off. Anyone have any ideas how to exit out of bootloader mode and go back to normal?

Thanks in Advance!

Please Log in or Create an account to join the conversation.

Bootloader mode 4 years 5 months ago #39724

  • alandbush
  • alandbush's Avatar
  • Offline
  • Premium Member
  • Premium Member
  • Posts: 103
  • Thank you received: 55
Perhaps the Reset button is the answer as detailed in the User guide .
Check out Section 10.4 MCU FIRMWARE UPDATE, in particular point 9.
The following user(s) said Thank You: devteam

Please Log in or Create an account to join the conversation.

Bootloader mode 4 years 5 months ago #39744

  • devteam
  • devteam's Avatar
  • Away
  • Administrator
  • Administrator
  • Posts: 9163
  • Thank you received: 1461
@EdvardGreig

You most likely just put the unit into bootloader mode (firmware mode to upgrade the firmware). When you powercycle, it will get back to normal mode. Feel free to contact us if any questions.

DevTeam
miniDSP, building a DSP community one board at a time.

For any official support, please contact our technical support team directly @ support.minidsp.com/support/home

Please Log in or Create an account to join the conversation.
  • Page:
  • 1
Moderators: devteam
Support
Community Forum
Community Support
Dirac Series
Bootloader mode