Welcome, Guest

NanoAVR DL IR Control - Question for DevTeam

NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.

Page:
1

TOPIC:

NanoAVR DL IR Control - Question for DevTeam 5 years 8 months ago #32743

ThM
Topic Author
Offline
New Member
Posts: 6
Thank you received: 0

Hi everyone!

My question goes to the DevTeam actually. Would it be possible in a next firmware to add one IR command to HDMI1 and another one to HDMI2 inputs? At now, it is the same IR command which toggles between HDMI1 input and HDMI2. This avoid its utilization in macros command like with the Harmony Hub remote can do. Indeed, if the Nano is set up to HDMI1 and if I choose to run a macro that uses HDMI2, then the IR command will be sent and it will be fine. But if I then turn everything off, and start the same macro agin, the input on the nano will be HDMI1, which will need a manual toggle to be on the right input.

Thanks!

Please Log in or Create an account to join the conversation.

NanoAVR DL IR Control - Question for DevTeam 5 years 8 months ago #32787

devteam Away Administrator Posts: 9145 Thank you received: 1456	@ ThM It's a sensible request. We'll push it to the engineer to see if it's possible for the future firmware/software release. HTH miniDSP, building a DSP community one board at a time.
	Please Log in or Create an account to join the conversation.

Page:
1

Moderators: devteam

Support

Community Forum

Community Support

Dirac Series

NanoAVR DL IR Control - Question for DevTeam