TOPIC:

Using the DLCT program, I can't proceed because the only test signal playback device among the displayed options is the nanoAVR DL, instead the DDRC-88A device as adviced in the user manual.
DLCT is v1.0.5 with Windows7 64-bit edition. Thank you for any ideas, Marco

marmasotti wrote:

Using the DLCT program, I can't proceed because the only test signal playback device among the displayed options is the nanoAVR DL, instead the DDRC-88A device as adviced in the user manual.
DLCT is v1.0.5 with Windows7 64-bit edition. Thank you for any ideas, Marco

Marco,

Are you sure you cannot proceed? This occurred when I set up my 88A last night, however it did not keep me from running a full calibration. I intend to open a support ticket unless "devteam" can explain why this is happening to both of us. It is currently 6:30AM in Hong Kong so hopefully someone will be able to address this soon...

Edit: A post on AVSForum indicates this is normal behavior, however I cannot find an official source: www.avsforum.com/forum/90-receivers-amps...21.html#post30721809

If it's showing nanoAVR DL, it will work.

Actually, I even didn't try to go further through the menu to avoid mess.
If the identifier, recognized differently, works the same I then will not care. I'll report on this later on the day.
However, the question remains, maybe wrong firmware, which is 2.16 in my unit?
Thanks, Marco

Hi Marco, the number sounds right but I'll check my unit later this evening. I'm pretty sure I'm on the latest version and it still says "nanoAVR DL".

Hi again Marco, my unit reports as 2.16 in DDRC-88 Utility and works fine.

HTH

Yes, my unit works fine too, as far as I can see a different name might not be a concern.
Thank you, marco

No need to worry Marco. nanoAVR or DDRC use similar software/firmware base. It's just a reporting that we've fixed in latest firmware issues.
Your unit will work fine.

DevTeam