TOPIC:

I am a noob at tuning or anything car audio technicals, even audio, but I wanted some good music in my car and have been building a setup. Planning to add in a dsp and from the reading the mindsp seems to be the easiest for a beginner.

Can some one send me some screen shots of their minidsp settings? I have installed the minidsp software on my laptop and trying to understand it before I go ahead and get the dsp and install it in my car.

For eg The first tab inout and bass management, I will be using Optical, so do I disable analog inputs or whats done here?

Is this how routing is configured for Dirac live? I now have a front and rear passive components and rear dual sub. Adding the dsp I am planning to run front as three way active adding a midrange. Rear and sub will remain the same. Should I also run active?

Image 1


If I want all my speakers tuned by Dirac is this mixing table correct?

Image 2

Do I need to set any value for PEQ? or just leave it default and just add the Xover based on speaker manufacturer values.


Image 3


Is the delay calculated as below?
delay(in ms) = Distance*34.4
Let's say my Front left tweeter is at 30 cm from listening position. then delay is 30*34.4=1032 ms ?

Is there anything else I need to set before running Dirac tuning?

**** I am unable to attach images inline ****