Welcome, Guest
Username: Password: Remember me
Here is the place to share your questions/comments about your setup of the UMIK-1 USB measurement microphone

NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.
  • Page:
  • 1


Below 20hz 4 years 1 month ago #44510

  • Stefan2906
  • Stefan2906's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 1
  • Thank you received: 0
I can see that the Umik only goes down to 20hz.
Is that correct? That really is a deal breaker.

Please Log in or Create an account to join the conversation.

Below 20hz 4 years 1 month ago #44642

  • devteam
  • devteam's Avatar
  • Away
  • Administrator
  • Administrator
  • Posts: 9243
  • Thank you received: 1521

The UMIK-1 is "rated" on the +/-1dB within 20~20kHz. That's a standard spec for all audio devices out there.
Now the UMIK-1 will easily measure much lower (down to 2Hz based on electronics). it's jut not calibrated that low as it's extremely hard to calibrate in a factory environment for so low.

Most customers use their UMIk-1 for sub.. You'll be all fine! :-)

Hoping that clarifies.

miniDSP, building a DSP community one board at a time.

For any official support, please contact our technical support team directly @ support.minidsp.com/support/home

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
Moderators: devteam