Welcome, Guest
Username: Password: Remember me
Here is the place to share your questions/comments about your setup of the UMIK-1 USB measurement microphone


NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.
  • Page:
  • 1

TOPIC:

Circuit Board Wiring Schematic (MIC+/MIC-/GND) 2 years 4 months ago #42013

  • scharfschutzen
  • scharfschutzen's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 5
  • Thank you received: 0
So my UMIK-1's internal wires broke from the circuit board while changing the dip-switches.
The yellow wire was connected to MIC- but I am unsure where the Blue and Red wires go. I am assuming the Red wire goes to MIC+ and the blue wire goes to GND but I don't want to just assume.

Can someone please confirm? I'd like to re-solder these, but I want to ensure they are correct so I don't cause damage to the circuit board.

I appreciate it advanced!

Please Log in or Create an account to join the conversation.

Circuit Board Wiring Schematic (MIC+/MIC-/GND) 2 years 3 months ago #42252

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Administrator
  • Posts: 8965
  • Thank you received: 1290
@scharfschutzen

Please contact our support team (support.minidsp.com) and we'd be happy to help!

DevTeam
miniDSP, building a DSP community one board at a time.

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
Moderators: devteam