Welcome, Guest
Username: Password: Remember me
Here is the place to share your questions/comments about your setup of the UMIK-1 USB measurement microphone


NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.
  • Page:
  • 1

TOPIC:

UMIK-1 not supported on an iPad running IOS 11.4 ? 3 years 9 months ago #39524

  • edstiles
  • edstiles's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 1
  • Thank you received: 0
Trying to install a UMIK-1 in a32 gig iPad running IOS 11.4 and Audio Tools (iPad model MP242LL/A). One and one half minutes after plugging in the mike while in Audio Tools, I get a pop up saying "This Accessory is not supported by this iPad". When I click "OK" on this message, the microphone reverts to Internal Mic 1 and 2. Note I am using an eBay purchased Lightning to USB adapter but I don't believe that is the problem.

Audio Tools is Version10.20.1.

I was able to get the Calibration file installed but that didn't make any difference. UMIK S/N is 701-5539.

Any suggestions???

Please Log in or Create an account to join the conversation.

UMIK-1 not supported on an iPad running IOS 11.4 ? 3 years 9 months ago #39694

  • devteam
  • devteam's Avatar
  • Away
  • Administrator
  • Administrator
  • Posts: 9120
  • Thank you received: 1417
@edstiles
Not sure what the issue could be here.. Are you using a valid/official Apple accessory? We've had that issue in the past.
Make sure that you use an apple accesory. Bootleg accesories are notorious to be buggy. :-)

DevTeam
miniDSP, building a DSP community one board at a time.

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
Moderators: devteam