Welcome, Guest
Username: Password: Remember me
Here is the place to share your questions/comments about your setup of the UMIK-1 USB measurement microphone


NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.

TOPIC: Gain 0

Gain 0 2 years 4 months ago #32051

  • mialapi
  • mialapi's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 2
  • Karma: 0
I received a umik mic with the gain factory set at o. Everything I'm reading says they were set at 12, and more recently set at 18. Is this in error? Or can I use it set at 0

Thanks
The administrator has disabled public write access.

Gain 0 2 years 4 months ago #32062

  • john.reekie
  • john.reekie's Avatar
  • Offline
  • Platinum Boarder
  • Posts: 3481
  • Thank you received: 1499
  • Karma: 137
It should be 18. It is possible though that it's the software you are seeing this with. Probably the best thing to do is open a support ticket over at support.minidsp.com with a screenshot.

HTH :)
I am not miniDSP support.

"You must ask the right questions." - Dr. Alfred Lanning's hologram.
-> Have you read the User Manual??
-> Have you drawn and posted a diagram?
-> Have you posted a screenshot?
-> Have you posted your config file?
The administrator has disabled public write access.
The following user(s) said Thank You: devteam

Gain 0 2 years 4 months ago #32156

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 8533
  • Thank you received: 1052
  • Karma: 157
Something is definitely not right here. Can you please start a tech support ticket with our team? (Support.minidsp.com)
MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.

Gain 0 2 years 4 months ago #32173

  • mialapi
  • mialapi's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 2
  • Karma: 0
The support team has instructed me to open the bottom of the mic, however it must be one that was glued on.
The administrator has disabled public write access.

Gain 0 2 years 4 months ago #32223

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 8533
  • Thank you received: 1052
  • Karma: 157
@ mialapi
Ok, it sounds like they are one the case to solve this issue. If possible, let's not try to have double talks as it's a bit confusing to track both.. :-)
Thanks!

DevTeam
MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.
Moderators: devteam