Welcome, Guest
Username: Password: Remember me
Here is the place to share your questions/comments about your setup of the UMIK-1 USB measurement microphone


NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.

TOPIC: UMIK-1 Calibration file phase

UMIK-1 Calibration file phase 2 years 10 months ago #28880

  • deChrLam
  • deChrLam's Avatar
  • Offline
  • Senior Boarder
  • Posts: 54
  • Thank you received: 5
  • Karma: 2
@DevTeam

Somebody asked about missing phase information here
Your answer:"Phase was only done for the first batch I'm afraid..... the offset is quite minor and consistent"

I would very much like to see how minor and consistent the phase offset is.
Do you have some example serial numbers for me for downloading here?: www.minidsp.com/images/umik/70xxxxx.txt
SERNO: 10025 is an example mike used on the HTS forum but the serial number is not in the same format as your downloader.

Cheers
The administrator has disabled public write access.

UMIK-1 Calibration file phase 2 years 10 months ago #28954

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 8533
  • Thank you received: 1052
  • Karma: 157
@ deChrLam

Unfortunately we don't log the phase inside the factory when the mics are being manufactured.. Maybe easiest that you compare it with say one of your microphone/interface for your specific application/specific test kit?

Devteam
MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.
Moderators: devteam