Welcome, Guest
Username: Password: Remember me
Here is the place to share your questions/comments about your setup of the UMIK-1 USB measurement microphone


NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.
  • Page:
  • 1

TOPIC:

Normal RTA readout in Lowend Freq? 6 years 6 months ago #24294

  • DozerSoldier
  • DozerSoldier's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 5
  • Thank you received: 5
Just got my UMIK-1
Is this low frequency noise floor normal?
Highpass in REW is set to on.
90degree cal file loaded.
It has the same thing going on in 2 computers I tried.
Can anyone plug theirs in and verify, and bring up RTA with no sounds in
their area going(ac/heater/washer/dryer/car running outside).
Thanks in advance.



Volume settings




Causing waterfall in low frequency to ring out forever.
However, it is below 30hz mostly, so not a big deal.

Please Log in or Create an account to join the conversation.

Last edit: by DozerSoldier.

Normal RTA readout in Lowend Freq? 6 years 6 months ago #24297

  • DozerSoldier
  • DozerSoldier's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 5
  • Thank you received: 5
The following user(s) said Thank You: devteam

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
Moderators: devteam