Welcome, Guest

Need help configuring your plug-ins? This is the place to ask the miniDSP community for help. Please read manual first to limit 101 questions.

NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.

Page:
1

TOPIC:

Cannot syn miniDsp 12 years 11 months ago #596

shumgaryhk
Topic Author
Offline
New Member
Posts: 15
Thank you received: 0

Hi,

I tried to use load the 2 way crossover plugin into the miniDsp board.

It can detect the miniDsp kit with serial#.

After click on the synchronize button, the popup window message jump to 137 Byteread=65 and then stop to prompt a message 'DSP firmware needs to be recovered...'

After click on Restore factory setting... button, the popup window message jump until 'Message from USB 439 Byteread=65' and then stop to prompt a message 'DSP firmware needs to be recovered...'

It keep prompt the same message after click 'Restore factory setting...'

What's the problem of this setup?

Please Log in or Create an account to join the conversation.

Re: Cannot syn miniDsp 12 years 11 months ago #601

devteam
Online
Administrator
Posts: 9161
Thank you received: 1460

Gary,

Please check your jumper settings... I'm guessing that you have your master jumper on the miniDSP maybe incorrectly located. It's simple:
- miniDSP alone: miniDSP MCLK jumper on "Master location"
- miniDSP with miniDIGI: miniDSP MCLK jumper on "Slave location"

Hope this makes sense. Please refer to the jumper chart to make sure you have it right.

Change the jumper with the power off, power the board (connect USB) then start the plug-in and you'll see that it will boot up fine.

Hope this makes sense,

miniDSP, building a DSP community one board at a time.

For any official support, please contact our technical support team directly @ support.minidsp.com/support/home

Please Log in or Create an account to join the conversation.

Re:Cannot syn miniDsp 12 years 11 months ago #604

shumgaryhk Topic Author Offline New Member Posts: 15 Thank you received: 0	Yes. forgot to change it back to master mode...thx.
	Please Log in or Create an account to join the conversation.

Re:Cannot syn miniDsp 12 years 11 months ago #605

devteam Online Administrator Posts: 9161 Thank you received: 1460	Issue Closed: Incorrect jumper location. miniDSP, building a DSP community one board at a time. For any official support, please contact our technical support team directly @ support.minidsp.com/support/home
	Please Log in or Create an account to join the conversation.

Re:Cannot syn miniDsp 12 years 11 months ago #612

shumgaryhk Topic Author Offline New Member Posts: 15 Thank you received: 0	Yes. it woks now....
	Please Log in or Create an account to join the conversation.

Page:
1

Moderators: devteam

Forum

Community Support

Software

Re:Cannot syn miniDsp