Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: PWR-ICE125 with dual voice coil subwoofer

PWR-ICE125 with dual voice coil subwoofer 8 months 6 days ago #36110

  • scott83
  • scott83's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
Hey all,

I am currently running a Sonos system with 4x Connect Amps and I would like to add an outdoor subwoofer for my outside deck speakers. I have been looking at the Polk Atrium Sub10. The specs on the Sub10 are:

Dual 2" voice coil, 8ohm, rated at 200W per coil.

Would I be okay to use a PWR-ICE125 set in BTL mode, and connect the two sub voice coils in parallel to it? That would give me a 4ohm load and the 450W output of BTL mode should be plenty to drive the 2x200W coils, correct?

Thanks,
Scott.
The administrator has disabled public write access.

PWR-ICE125 with dual voice coil subwoofer 8 months 12 hours ago #36208

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 7884
  • Thank you received: 919
  • Karma: 149
@ Scott

The PWR-ICE125 would be fine it would sound.. For subs we'd typically recommend the PWR-ICE250 for ample power but you should be fine with your setup!

DevTeam
MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.
Moderators: devteam
Time to create page: 0.109 seconds