Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: How much power to 8 ohms.

How much power to 8 ohms. 3 weeks 1 day ago #32857

  • emre
  • emre's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 9
  • Karma: 0
Hi I have a pwrice125. It says it sends 125 watts at 4 ohms. I have an 8 ohm woofer so how much power will go to 8 ohms?

The reason I ask is, my woofer's power handling is 80 watts (long term max power is 150watts) and should I be worried about sending more than it handles at 8 ohms?

Thanks...
Attachments:
The administrator has disabled public write access.

How much power to 8 ohms. 2 weeks 3 days ago #32902

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 5759
  • Thank you received: 705
  • Karma: 132
@ emre

Beautiful setup! Typically, the recommended amp rating is 2 x the driver... You must already know that for asking that question.. ;-)
The PWRICE has a protection, just be aware of that limitation when you drive the speaker though.

DevTeam
MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.

How much power to 8 ohms. 2 weeks 3 days ago #32905

  • emre
  • emre's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 9
  • Karma: 0
Thank you but I did not get my answer :)

How much power does the pwrice-125 send to 8 ohms? B)
Last Edit: 2 weeks 3 days ago by emre.
The administrator has disabled public write access.

How much power to 8 ohms. 2 weeks 10 hours ago #32938

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 5759
  • Thank you received: 705
  • Karma: 132
@ emre

Check out the datasheet for the Icepower module for very complete specs:
www.icepower.dk/files/solutions/icepower...eet_1_3_20151203.pdf
p9 will give you all the answers for rating/load/power.

DevTeam
MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.
Time to create page: 0.114 seconds