Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: PWR-ICE 125WD build in dimensions

PWR-ICE 125WD build in dimensions 3 months 4 weeks ago #32040

Hello,

Could anybody tell me what the build in dimensions are for the PWR-ICE 125WD (so not the plate but the part behind the plate)? I would like to mount them in a board, so I need to cut out a hole big enough for the module to fit in, but hopefully small enough so the board keeps some strength.

If anybody could help me it would be great, as I am building it this weekend but don't have my amp in the place I am building.

Thank you.
The administrator has disabled public write access.

PWR-ICE 125WD build in dimensions 3 months 2 weeks ago #32151

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 5848
  • Thank you received: 709
  • Karma: 132
Hello

Sorry for missing your post.. An opening of 137 x 166 should do it. That's what we did here based on some drawings of a demo box we built.

HTH

devTeam
MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.
Time to create page: 0.120 seconds