Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: PWR-ICE125WD - is there a standby/remote on mode?

PWR-ICE125WD - is there a standby/remote on mode? 7 months 1 week ago #30612

  • EyalR
  • EyalR's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
Hi,
I'm interested in this amp for a sub (already have the 2X4 for it). Does it have an auto sensing signal turn on? I didn't see it has a 12V remote on input.
Or do I have to press the on/off button every time?

Thanks!
The administrator has disabled public write access.

PWR-ICE125WD - is there a standby/remote on mode? 7 months 1 week ago #30666

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 5848
  • Thank you received: 709
  • Karma: 132
@ EyalR

Unfortunately no auto sensing on this amplifier.. :-( If you want +12V control, you might need to do it via a voltage triggered AC plug. (+12V trigger).

Devteam
MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.
Time to create page: 0.092 seconds