Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: Stuck in Restore Factory Settings loop

Stuck in Restore Factory Settings loop 3 months 3 weeks ago #37445

  • PlinytheWelder
  • PlinytheWelder's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 3
  • Thank you received: 1
  • Karma: 0
After upgrading to 1'30 firmware the plugin advised me to Restore Factory Settings.
In the little sub window with 2 lines, upper line says Device Found, lower window says
Message from USB 116011 Byteread=65
The number after USB increments about 2500 then the Restore window ops up and I click on it and the cycle repeats.
Is this OK? And does this end or am I in a loop?
The administrator has disabled public write access.

Stuck in Restore Factory Settings loop 3 months 3 weeks ago #37447

  • PlinytheWelder
  • PlinytheWelder's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 3
  • Thank you received: 1
  • Karma: 0
Ignore, I found the problem...
The administrator has disabled public write access.
The following user(s) said Thank You: devteam
Moderators: devteam
Time to create page: 0.090 seconds