Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: nanoAVR DL setup question

nanoAVR DL setup question 1 month 3 weeks ago #36937

  • Shades228
  • Shades228's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
I'm thinking about purchasing the nanoAVR DL. I have a Sony 1080 and I would have my xbox one s and AppleTV 4k connected to it then to the Sony input. My subs are going to be driven by an inuke 6000dsp. I'm assuming that I would configure the subs using REW and then run Dirac Live to get the other speakers dialed in. I'm guessing that I wouldn't use DCAC and if so I'm concerned about how the other inputs would sound.
The administrator has disabled public write access.

nanoAVR DL setup question 1 month 2 weeks ago #37017

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 7541
  • Thank you received: 860
  • Karma: 148
@ Shades228

The important first question to ask is to make sure that you indeed have the ability to enable PCM on each of these.. (limitation of the unit that it can't accept) .Also not that we don't support 4k on this unit (up to HDMI1.4only)

Indeed tuning the subs first using REW (and whatever DSP you have for these?) and then using Dirac overall..

DevTeam
MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.
Time to create page: 0.128 seconds