Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: nanoAVR calibration question?

nanoAVR calibration question? 4 months 3 days ago #34730

  • mcdansley
  • mcdansley's Avatar
  • Offline
  • Junior Boarder
  • Posts: 24
  • Thank you received: 2
  • Karma: 0
I have a few nanoAVR DL calibration questions. The manual was not completely clear.

1. Must a source component (i.e. bluray player) be connected and on to perform installation and calibration?
2. Must the setting in the nano be 7.1 or 5.1? My pre-pro, Emotiva UMC-200, is a 7.1 processor. But, I'm only running a 5.1 set-up.
3. What is the max. length HDMI and USB cables (for unit and microphone) that can be used?

Thanks
The administrator has disabled public write access.

nanoAVR calibration question? 4 months 3 days ago #34732

  • john.reekie
  • john.reekie's Avatar
  • Offline
  • Platinum Boarder
  • Posts: 3061
  • Thank you received: 1303
  • Karma: 126
1. "If you do not hear audio when pressing a Test button, ensure that an HDMI video source is connected, selected, and not asleep"
2. 7.1, because the Emotiva will presumably downmix the last two channels if you have source content in them.
3. www.cablechick.com.au/blog/cable-length-guide/
I am not miniDSP support.

"You must ask the right questions." - Dr. Alfred Lanning's hologram.
-> Have you read the User Manual??
-> Have you drawn and posted a diagram?
-> Have you posted a screenshot?
-> Have you posted your config file?
The administrator has disabled public write access.
The following user(s) said Thank You: devteam, mcdansley
Time to create page: 0.206 seconds