Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: Channel assignment

Channel assignment 1 year 10 months ago #29478

  • weber30
  • weber30's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 4
  • Karma: 0
This is a very generalized question. How are the channels in a 5.1 PCM signal assigned. Does each channel contain an info which tells te device which one it is or is there a fixed order (e.g. 1=FL, 2=FR, 3=...)? If I put Channel Mode to 5.1 will the next device in line ignore the two other channels (RL,RR)? If so would that basically mean for a nanoavr HDA that the HDMI outputs only 5.1 channels but could use the two remaining ones via analog out?
The administrator has disabled public write access.

Channel assignment 1 year 9 months ago #29578

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 7788
  • Thank you received: 904
  • Karma: 150
@ weber30

If you're talking of the nanoAVR HDA, the 5.1 will mean that it will ignore the last 2ch over HDMI. (as it would basically only stream 6ch)
You could however still grab 5.1 and turn it into a 5.3 for the analog out thanks to the matrix mixer for the analog out only.

Makes sense?

MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.
Moderators: devteam
Time to create page: 0.094 seconds