Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: NanoAVR DL with ip problem

NanoAVR DL with ip problem 3 months 2 weeks ago #26399

  • sufgi123
  • sufgi123's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
I have a problem with my NanoAVR DL .
I can't connect it with the android application.
The application recognize the device, but I see ip 169.254.88.* instead of 192.168.0.* and I can't connect it.
I downgrade the firmware back to 1.26 and still the same problem.
I also connect it to other router but no change.
I connect it to my laptop directly and open the NanoAVR BM software, but it not recognize the device.
How can I solve it ?
The administrator has disabled public write access.

NanoAVR DL with ip problem 3 months 1 week ago #26423

  • sly
  • sly's Avatar
  • Offline
  • Expert Boarder
  • Posts: 155
  • Thank you received: 88
  • Karma: 28
A 169 IP address means that your device was not assigned an IP address from your router. The simplest solution would be to reboot your router and power cycle your NanoAVR. Make sure your router has DHCP enabled and is not using static IP addresses. Log into your router and see if it recognized your NanoAVR. You should see what IP address it was assigned. If you see a 192 IP address, then try to connect your Android again.
The administrator has disabled public write access.
The following user(s) said Thank You: devteam
Time to create page: 0.099 seconds