Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: Is it possible to use a Dayton EMM-6?

Is it possible to use a Dayton EMM-6? 1 year 5 months ago #20166

  • scintilla
  • scintilla's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 6
  • Karma: 0
I bought a Cross-Spectrum calibrated EMM-6 for use with acourate and I have a TC Electronic Impact Twin interface. Is there any reason I could not use this pair in lieu of the UMIK-1 with the nanoAvr DL?
The administrator has disabled public write access.

Is it possible to use a Dayton EMM-6? 1 year 5 months ago #20173

  • john.reekie
  • john.reekie's Avatar
  • Offline
  • Platinum Boarder
  • Posts: 2287
  • Thank you received: 863
  • Karma: 99
The software will only recognise a UMIK-1.
I am not miniDSP support.

"You must ask the right questions." - Dr. Alfred Lanning's hologram.
-> Have you read the User Manual??
-> Have you drawn and posted a diagram?
-> Have you posted a screenshot?
-> Have you posted your config file?
The administrator has disabled public write access.
The following user(s) said Thank You: devteam

Is it possible to use a Dayton EMM-6? 1 year 5 months ago #20241

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 5132
  • Thank you received: 632
  • Karma: 119
Very good answer from John already. The software must use the UMIK-1 as per the product page and user manual details.

DevTeam
MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.
Time to create page: 0.101 seconds