TOPIC:

Hi,

I just bought the MiniDSP and 2-way plug-in. The setup seems ok, I will describe here.

1. Install the 2-way plug in and then plug-in the USB cable. Synchronize
the 2 boards. NO problem here.The Blue LED keeps flashing I assume it
is normal.
2. Reset to factory settings seems OK, ie no errors
3. The next part seems unusual, i.e I change the x-over settings
look at the output using MLS, no diffrent no matter what settings I
set. Channel 1 seems to set as low pass filter and Channel 2 set as
high pass filter no matter what setting I set to.
I even mute all the channels, signals seem to get through. BTW
I did not change any hardware settings.


Any suggestions

MMMh, you sure that you're synchronized to the board? i.e. seeing real time meters? Sounds like you're not.

I hit the synchronize button(green) it goes off and does not come on again. I was able to reset the MINIdsp to factory setting though.

Does the Green syn button needs to come on again after I hit it?

The Sync button will not come after you pressed it unless you unplug the board. That's because from the point you synchronized, all changes are live from there on. As per user manual:
"Once the board fully synchronized, a “Successful connection to the board” message pops up. From this point on, all changes to the configuration will be real time and live, therefore giving you the chance to hear the effect of your equalization, filtering, tuning…"

I know now I don't have
Microsoft• ® .NET framework v3.5
installed, I will install it.

Thks for your help.