Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: Integrating a 2x4HD with an isolator

Integrating a 2x4HD with an isolator 2 months 2 weeks ago #42661

  • Frottage
  • Frottage's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 2
  • Karma: 0
Hi there, I’m currently running a Jensen Sub 2xx between my receiver and my sub amps. Had some ground loop noise before and the isolator eliminated it very well. I’d like to add a 2x4hd as well but would like to know where you’d recommend inserting it into the signal path, before or after the isolator? Thanks!
The administrator has disabled public write access.

Integrating a 2x4HD with an isolator 2 months 1 week ago #42711

  • devteam
  • devteam's Avatar
  • Online
  • Administrator
  • Posts: 8402
  • Thank you received: 1013
  • Karma: 154
@Frottage

Not sure yet if you'll need the isolator :-) but if you do, you can use it after the 2x4HD, it should be fine.

DevTeam
MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.
Moderators: devteam