Welcome, Guest

NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.

TOPIC: Dirac3 Signal/Noise issue in setup.

Dirac3 Signal/Noise issue in setup. 1 month 1 week ago #54470

gemohler Offline Fresh Boarder Posts: 7 Karma: 0	I have a new 88A, and im new to DSP work, but so far it's fairly intuitive. I cannot get the Dirac software to do anything but complain: https://www.flickr.com/gp/[email protected]/Tr9M27 It's a relatively quiet room, it complains even to very loud levels. Should I raise master output a lot more, and lower mic gain? At a loss. TY
	The administrator has disabled public write access.

Dirac3 Signal/Noise issue in setup. 1 month 1 week ago #54478

devteam Online Administrator Posts: 8814 Thank you received: 1233 Karma: 167	@TY You're getting this error as you most likely don't have 8ch. Please follow our manual to configure the channel count correctly from the 88BM plugin (p9). DevTeam
	miniDSP, building a DSP community one board at a time. The administrator has disabled public write access. The following user(s) said Thank You: gemohler

Dirac3 Signal/Noise issue in setup. 1 month 1 week ago #54479

gemohler Offline Fresh Boarder Posts: 7 Karma: 0	I will work on that tomorrow. You are right, Im not using the 8th channel. You -could- improve the error message on this..
	The administrator has disabled public write access.

Dirac3 Signal/Noise issue in setup. 1 month 1 week ago #54480

gemohler Offline Fresh Boarder Posts: 7 Karma: 0	(delete, duplicate)
	Last Edit: 1 month 1 week ago by gemohler. The administrator has disabled public write access.

Moderators: devteam

Forum

Community Support

Dirac Series

Dirac3 Signal/Noise issue in setup.