Welcome, Guest
Username: Password: Remember me

NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.

TOPIC: DDRC-24 does not work with 192kHz 24bit source

DDRC-24 does not work with 192kHz 24bit source 5 months 1 week ago #43976

  • senirrossi
  • senirrossi's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
Dear Forum members,

I am currently setting up my DDRC-24. It works fine with analog audio sources and one digital one over toslink with samplerate 48kHz. However, I do not get it to work with a digital source with samplerate 192kHz 24bit over toslink, although the Input should support this. (I know that the internal samplerate is just 48kHz). I get the source to work with a Denon AVR without problems, so I can assume that cable and data Integrity is not an issue.

Who can help. It would be really unfortunate, if I do not get this to work!
The administrator has disabled public write access.

DDRC-24 does not work with 192kHz 24bit source 5 months 15 hours ago #44192

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 8704
  • Thank you received: 1101
  • Karma: 158
@senirrossi

Not sure what could be the case... Make sure your source is indeed a PCM, stereo. We test here with 192k during QC as part of the procedure under the Audio Precision. No problem.

DevTeam
miniDSP, building a DSP community one board at a time.
The administrator has disabled public write access.

DDRC-24 does not work with 192kHz 24bit source 5 months 14 hours ago #44197

  • pduk
  • pduk's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 4
  • Thank you received: 2
  • Karma: 0
In case this helps, I've also had failure to use 192/24 over optical from my blu ray player into my 22D. However, when I use the coaxial link it works fine. I assumed it was down to quality of signal or cable but didn't worry about it too much as I prefer co-ax anyway.
The administrator has disabled public write access.

DDRC-24 does not work with 192kHz 24bit source 4 months 1 week ago #44438

  • Juoigâ
  • Juoigâ's Avatar
  • Offline
  • Expert Boarder
  • Posts: 159
  • Thank you received: 27
  • Karma: 9
iirc some toslink tx/rx have a limitation to 96kHz
The administrator has disabled public write access.
The following user(s) said Thank You: devteam
Moderators: devteam