Welcome, Guest
Username: Password: Remember me

NOTE: This is a "Community" forum. Please be mindful that community members are here to help as part of a community effort. We therefore appreciate your effort in keeping this forum a happy place!

If you have a specific issue (e.g. hardware, failure) and want help from our support team, please use our tech support portal (Support menu - > Contact Us).
Thanks a lot of your help in making a better community.

TOPIC: Very low volume after my first mesauring

Very low volume after my first mesauring 1 year 2 months ago #43894

Hi there
After my first run and upload on my 22 the volume on the dirac2 is so much lower then on my previous dirac1 meausurment. What im a doing wrong. Doing it on my macmini
The administrator has disabled public write access.

Very low volume after my first mesauring 1 year 2 months ago #43927

  • stratvm
  • stratvm's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 4
  • Thank you received: 3
  • Karma: 0
i just did my dirac 2.0 update, it was a real pain but it is a massive improvement so it worthed it - i had the same problem as you, the master volume was set too low for me in the volume calibration menu. the measurement volume was also much lower than the actual volume of my system for some reason.

just unclick that lock button and you can increase the volume and then re-export the target curve to the minidsp plugin.
The administrator has disabled public write access.

Very low volume after my first mesauring 1 year 2 months ago #44020

Where do i uncklick the lock button?
The administrator has disabled public write access.

Very low volume after my first mesauring 1 year 2 months ago #44094

  • stratvm
  • stratvm's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 4
  • Thank you received: 3
  • Karma: 0
top left in volume calibration menu as seen on the attached pic

http://prntscr.com/p9hnyj
The administrator has disabled public write access.

Very low volume after my first mesauring 1 year 1 month ago #44227

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 8767
  • Thank you received: 1156
  • Karma: 165
FYI, p22 of the user manual should answer that question?
www.minidsp.com/images/documents/miniDSP...%20User%20Manual.pdf


DevTeam
miniDSP, building a DSP community one board at a time.
The administrator has disabled public write access.
Moderators: devteam