Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: Nano Avr dl questions

Nano Avr dl questions 4 months 4 days ago #37941

Hi There,

Have just purchased and set up a nano avr DL and have a few questions..

First off why on earth did it only come with 2xhdmi inputs?! I don't see why you wouldn't want to apply it to you whole system is there any way of obtaining more inputs? It seems to really apply it to your whole system, for an all in one avr, you either need to buy 3 units 2 with hdmi and one analouge or buy a new pre with dirac installed?! Im running a cambridge 751r

Secondly when i run my test measurements dirac only sends up to 70hz through the sub, and full range to tge speakers. I set my speakers to large and the crossover to 120hz for the test... While i have full range speakers all round, I usually prefer to run my system crossed at 120hz and speakers set to small because i have a very good sub and i can run the system harder that way. I had the crossover set to 120hz when i did the sweeps too but does it mean the lower end of the front and surround measurements was actually the sub? Also why does the sub only go up to 70hz? Wouldn't you get a better time alignment from a higher freq?
The administrator has disabled public write access.
Moderators: devteam
Time to create page: 0.100 seconds