Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: NanoAVR DL IR Control - Question for DevTeam

NanoAVR DL IR Control - Question for DevTeam 1 month 3 days ago #32743

  • ThM
  • ThM's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 6
  • Karma: 0
Hi everyone!

My question goes to the DevTeam actually. Would it be possible in a next firmware to add one IR command to HDMI1 and another one to HDMI2 inputs? At now, it is the same IR command which toggles between HDMI1 input and HDMI2. This avoid its utilization in macros command like with the Harmony Hub remote can do. Indeed, if the Nano is set up to HDMI1 and if I choose to run a macro that uses HDMI2, then the IR command will be sent and it will be fine. But if I then turn everything off, and start the same macro agin, the input on the nano will be HDMI1, which will need a manual toggle to be on the right input.

Thanks!
The administrator has disabled public write access.

NanoAVR DL IR Control - Question for DevTeam 4 weeks 1 day ago #32787

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 5759
  • Thank you received: 705
  • Karma: 132
@ ThM

It's a sensible request. We'll push it to the engineer to see if it's possible for the future firmware/software release.

HTH
MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.
Time to create page: 0.102 seconds