Welcome, Guest
Username: Password: Remember me
NOTE: This forum is community powered. Please be mindful that long time community members are here to help as part of a community effort. If you have a specific issue (e.g. hardware, failure), please use our tech support portal (Support menu - > Contact Us). Thanks a lot of your help in making a better community. :-)

TOPIC: usb not recognised after fw update

usb not recognised after fw update 1 year 4 weeks ago #30237

  • jasonski73
  • jasonski73's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 3
  • Thank you received: 1
  • Karma: 0
I have just purchased an earlier version of the ddrc-88a
which needed the new firmware etc, I followed the instructions on page 71 every thing went fine replace the internal usb from the main board back to the daughter board etc. uninstalled MiniDSP_8x8_IO_v2_3 and installed DDRC_88_BM_v1_5
powered the unit backup and now the computer will not recognize the device, after a few attempts i went in to windows devices
and removed unknown device, then searched for hardware changes and windows picked the 88a up but still as unknown device,
yet displayed your driver is installed. long story 88bm software will not recognize the unit. I am stuck any advice will be appreciated
The administrator has disabled public write access.

usb not recognised after fw update 1 year 3 weeks ago #30282

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 7175
  • Thank you received: 795
  • Karma: 139

It sounds like you already got a tech support ticket opened with our team? easiest to let them handle the case then. Thanks!

MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.
Time to create page: 0.168 seconds