Welcome, Guest
Username: Password: Remember me
A freeware application by JLO to build correction file for OpenDRC or DRC. Send your comments/questions here.

TOPIC: Creating 96KHz filters

Creating 96KHz filters 3 years 2 months ago #10207

  • micfre
  • micfre's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 2
  • Thank you received: 1
  • Karma: 0
This software is very promising. On the weekend I used it, with HolmImpulse IR files, to create a filterset. At 48KHz it works and sounds beautifully. I cannot, however, get it to output a filterset at 96KHz even when using the settings per the attached screenshot. My input IR files are 32-bit floating-point 96KHz; the output from Align2 is a 48KHz filter.

It would seem that the dropdown in the top right of the UI should be set to 96KHz and all would be fine, but that's not a possibility (only 41.1 and 48KHz are there).

Thinking further down that line, it would be great if that were enabled and when a new freq is selected, then the DRC config file and target curve files would be immediately updated to match!

Many thanks for the work on this.
Attachments:
The administrator has disabled public write access.

Creating 96KHz filters 3 years 2 months ago #10245

  • jlo
  • jlo's Avatar
  • Offline
  • Junior Boarder
  • Posts: 25
  • Thank you received: 5
  • Karma: 4
I have no problem to add 88.2 and 96kHz in the menu, but I have to check if all other functions will then work fine. Give me some days....
But I'm a bit skeptical of any audible improvment .
The administrator has disabled public write access.

Creating 96KHz filters 1 year 9 months ago #18019

  • oldspeaker
  • oldspeaker's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
Hallo I´m new user from Germany,

and I´m also interested in creating 96 kHz Filter for my OpenDRC DI

Thank you
The administrator has disabled public write access.
Time to create page: 0.168 seconds