Welcome, Guest
Username: Password: Remember me

TOPIC: Measurement buttons greyed out in AcourateDRC

Measurement buttons greyed out in AcourateDRC 4 years 5 months ago #19284

  • marmasotti
  • marmasotti's Avatar
  • Offline
  • Senior Boarder
  • Posts: 53
  • Thank you received: 2
  • Karma: 0
I am not getting enabled the Test Signal and Logsweep Recording buttons in the measurement panel, despite the designated inputs and outputs, through the Asio4all interface, are apparently set, as the attached pictures show.
The playback device is an OpenDRC-DA, connected and switched on.
I'm still unregistered, might be that the cause?
Attachments:
The administrator has disabled public write access.

Measurement buttons greyed out in AcourateDRC 4 years 5 months ago #19286

  • marmasotti
  • marmasotti's Avatar
  • Offline
  • Senior Boarder
  • Posts: 53
  • Thank you received: 2
  • Karma: 0
attached second picture showing
Attachments:
The administrator has disabled public write access.

Measurement buttons greyed out in AcourateDRC 4 years 5 months ago #19305

  • devteam
  • devteam's Avatar
  • Offline
  • Administrator
  • Posts: 8533
  • Thank you received: 1052
  • Karma: 157
@ marmasotti,

Might be best that you contact AudioVero directly for this.. Maybe they can help answer?
Being a 3rd party software we only provide this section of the forum to help provide coverage (i.e. give oportunity to the developer) but we're certainly not responsible for any support for it.

DevTeam
MiniDSP, building a DIY DSP community one board at a time.
The administrator has disabled public write access.

Measurement buttons greyed out in AcourateDRC 4 years 5 months ago #19308

  • marmasotti
  • marmasotti's Avatar
  • Offline
  • Senior Boarder
  • Posts: 53
  • Thank you received: 2
  • Karma: 0
I'll do that and eventually post here what was the problem.
Thank you.
The administrator has disabled public write access.
Moderators: devteam